fire tube three pass wet back energy source is natural gas

Product thermal capacity: 4-35 t/h
Working pressure: 1.0-2.5 MPA
Outlet temperature:: 184-350 ℃
Available fuel: Bituminous coal, lean coal, anthracite
Available industries: Heating, chemical, food, tobacco, textile, print and dyeing, feed, medicine, building materials, wine, hospital

>Water-tube boiler - Wikiped

Water-tube boiler - Wikipedia

The older fire-tube boiler design, in which the water surrounds the heat source and gases from combustion pass through tubes within the water space, is a much weaker structure and is rarely used for pressures above 2.4 MPa (350 psi). A significant advantage of the watertube boiler is that there is less chance of a catastrophic failure: there is

Get A Quote

>Scotch marine boiler - Wikiped

Scotch marine boiler - Wikipedia

Gases and smoke from the furnace pass to the back of the boiler, then return through the small tubes and up and out of the chimney. The ends of these multiple tubes are capped by a smokebox, outside the boiler shell. The Scotch boiler is a fire-tube boiler, in that hot flue gases pass through tubes set

Get A Quote

>The Difference between Wetback and Dryback Boilers - YouTu

The Difference between Wetback and Dryback Boilers - YouTube

May 16, 2016· On today's episode of The Boiling Point, Gerald and Ritchie address a topic that WARE gets a lot of questions about—the difference between wetback and …

Get A Quote

>Firetube vs Watertube Boilers: a Comparis

Firetube vs Watertube Boilers: a Comparison

Feb 19, 2015· There are a number of considerations to factor when determining the best boiler for your steam generation needs like operating pressure, steam pounds/hour output, demand fluctuation, general application requirments and total cost of ownership, etc. Two primary boiler types, the firetube boiler and the watertube boiler, are essentially opposite in design. The firetube boiler passes combustion

Get A Quote

>Petropedia - What is Fire Tube? - Definition from Petroped

Petropedia - What is Fire Tube? - Definition from Petropedia

A Fire Tube is specially used in oil and gas production to suffice the heating needs of other large equipment such as gas production units, oil refineries, treaters and heaters. This tube is basically used to supply air to the burner, where there is a low-pressure environment containing burner fuel that reacts with the air and ignites.

Get A Quote

>Scotch Marine Boiler | Three Pass Wetback | Series 4

Scotch Marine Boiler | Three Pass Wetback | Series 400

Three and four pass dry back boilers have tube sheets with large temperature variations and this results in premature tube failure and cracks in the tube sheets. Easy Access Since there is no large refractory rear door, one man can easily remove the rear cover plates for access to the tubes.

Get A Quote

F]

Boiler room Guide - Cleaver-Broo

[PDF]

Boiler room Guide - Cleaver-Brooks

through the third pass tubes. The hot gas travels toward the upper portion of the rear head where it’s turned and directed through the fourth pass tubes. From there, after giving up most of the energy from the combustion process, the gas is directed into the stack and vented to the atmosphere. Figure 1-1: Firetube Cut-Away gAS TrAiN OiL pipiNg

Get A Quote

>Firetube Boilers - Two Pass Wet-Back (SG) - Performan

Firetube Boilers - Two Pass Wet-Back (SG) - Performance

The wet back design refers to water at the back of the boilers inversion chamber thus eliminating the need for refractory. Another feature is that the tubes are both expanded and welded to the tube-sheets. The SG Firetube Boilers are only available in a two pass design.

Get A Quote

>Water for Power Plant Cooling | Union of Concerned Scientis

Water for Power Plant Cooling | Union of Concerned Scientists

Oct 05, 2010· Wet-recirculating or closed-loop systems reuse cooling water in a second cycle rather than immediately discharging it back to the original water source. Most commonly, wet-recirculating systems use cooling towers to expose water to ambient air. Some of the water evaporates; the rest is then sent back to the condenser in the power plant.

Get A Quote

>Investigating Natural Gas Systems - CFI train

Investigating Natural Gas Systems - CFI trainer

The fire investigator should have a basic understanding of the potential role of natural gas as a fuel source, an ignition source, and a factor in fire spread. The fire investigator should also know the tests that may be required as part of the fire investigation when natural gas piping or equipment is involved.

Get A Quote

>How to Respond to Natural Gas Emergencies - Fire Resc

How to Respond to Natural Gas Emergencies - Fire Rescue

Sep 01, 2014· Energy companies have developed alternative processing methods to create natural gas, and currently there is a boom in natural gas in North America that has reduced gas prices and encouraged its use. Transmission pipelines transport the natural gas at pressures of up to 1,500 psi throughout the country to local natural gas distributors.

Get A Quote
Contact us
Tel

0086-510-68530066

Chat online

Online message


Gas-fired(oil-fired) boilers
Coal-fired boilers
Biomass-fired boilers
Thermal oil heaters
Hot water:0.7-14 MW
14.1-21 MW
21.1-29 MW
29.1-75 MW
Steam :  1-10 t/h
11-20 t/h
21-90 t/h
91-140 t/h